300mm Laundry Chute Kit – Two Storey home with lid, finishes approx. 500mm from ceiling level and is designed for a single straight drop.
The size of the laundry chute design depends on the amount of space you have available. The encasement determines the area for the chute. Below we have listed the minimum boxing needed.
The minimum boxing required:
300 mm diameter laundry chute is 400 mm x 450 mm
Laundry chute location.
Typical locations for the start of a laundry chute are on the landing, family bathroom or en-suite. Most laundry chutes finish in the utility room, kitchen or ground floor cupboard with a laundry basket below. Our laundry chutes can either finish at a high level (between 150mm and 500mm from the ceiling) or lower around 1400mm off the finished floor level. To use space efficiently, it is best to have the chute finishing about 150mm below the ceiling above a shelf where the laundry basket resides. This allows space underneath to be used.
Mounting brackets hold the chute in place and are always located on the first component below a door and on the last piece at the bottom, which is usually a 500mm or 1000mm end piece. A safe rule of thumb is to use a mounting bracket per floor or every third component. Locking bands are located on a join of two components where there is no bracket. They stop the chute from twisting and you don’t need one on every join. Our installation manual takes you through the process step by step.
The laundry chute doesn’t need to be straight; it must have a continuous fall for the laundry. If you need to change direction, use 45°, 30° or 15° elbows.
Included in this Laundry Chute kit:
1 x Laundry Chute Lid (30125)
1 x 1000mm Ext Piece (31000)
2 x Mounting Bracket (30190)
1 x Locking Band (30180)
1 x 500mm End Piece (30500E)